Page 31 - LON-bus components

Connection diagram LM 0/16 mod.1 and 16/0 mod.2

Technical data:
1. Type of construction: 10. Neuron chip:
snap-on housing 3150, 10 MHz + 64kB Flash-EEPROM
145 x 111 x 50mm high 11. Transmission:
2. Degree of protection: LON FTT10A two wire (twisted-pair),
IP20 78kbps, max. 2,7km
3. Weight: 12. Bus connection:
approx. 300g isolated transceiver, 500V disconnecting
4. Climatic conditions: insulation voltage
in accordance with UNITRO-Standard 13. Output contacts LM 0-16 mod.1:
5. Connection: 16x transistor outputs, 24V DC, 250mA
screw-type terminals/ plug connection (sink), continuous signal and clocked exter-
or spring-loaded terminals max. 2,5mm² nally synchronized with 2 flash frequencies
separation voltage 2000Vrms
6. Function buttons: optional opto-mos output (short circuit)
reset button
service button 14. Output contacts LM 0-16 mod.2:
16x transistor outputs, 24V DC, 250mA
7. Supply voltage: (source), continuous signal and clocked
24V AC/DC, 100mA ± 10% externally synchronized with
8. Max. fuse: 3 flash frequencies
4A medium slow separation voltage 2000Vrms
9. LED-display: 15. Output contacts LM flash:
power LED green 2x transistor outputs 24V DC, 3A for
service LED yellow: flashing = device not flash synchronization
initialized 16. Leakage distances and clearances:
continuous light = error in accordance with UNITRO-Standard
LM 0/16 mod.1 and mod.2 for every output
1x red LED 17. EMC, immunity of interference:
UNITRO-Standard,
in accordance with EN 61000

subject to change Page 130